Steps
1. Lift the Mylar that covers the system board.
2. Slide the power-adapter port at an angle into the slot on the palm-rest and keyboard assembly and adhere the power-adapter
port cable to the system board.
3. Connect the power-adapter port cable to the system board.
4. Place the power-adapter port bracket on the power-adapter port.
5. Align the screw holes on the power-adapter port bracket with the screw holes on the palm-rest and keyboard assembly.
6. Replace the two screws (M2x4) that secure the power-adapter port bracket to the palm-rest and keyboard assembly.
7. Route the display cable through the slot on the palm-rest and keyboard assembly.
8. Connect the Alien head LED-cable to the system board.
9. Adhere the display cable to the system board.
10. Connect the display cable to the system board and close the latch to secure the cable.
11. Adhere the tape that secures the display-cable connector latch to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
Before working inside your computer
2. Remove the
3. Remove the
4. Remove the
42
