Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
●
Phillips screwdriver #1
●
Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then
place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when
the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a
component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Screw type
Quantity
Screw image
Base cover
M2.5x14 (captive screw)
2
Base cover
M2.5x6 (captive screw)
2
Base cover
M2.5x6
4
M.2 2230 or M.2 2280 solid-state
drive in SSD Slot one
M2x4
2
M.2 2230 or M.2 2280 solid-state
drive in SSD Slot two
M2x4
2
Wireless-card bracket
M2x4
1
Rear-I/O cover
M2x3
3
Rear-I/O cover
M2.5x6
2
Battery
M2x3
3
10