Steps
1. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
2. Replace the four screws (M1.6x1.8) that secure the I/O board to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure from step 3 to step 20 in
NOTE: The system board can be removed and installed along with the heat sink. This simplifies the removal and installation
procedure and avoids breaking the thermal bond between the system board and heat sink.
2. Install the
.
3. Install the
.
4. Install the
5. Install the
6. Install the
.
7. Install the
8. Install the
.
9. Follow the procedure in
After working inside your computer
.
Keyboard
Removing the keyboard bracket
Prerequisites
1. Follow the procedure in
Before working inside your computer
2. Remove the
3. Remove the
4. Remove the
5. Remove the
6. Remove the
7. Remove the
8. Remove the
.
9. Remove the
56
