Align Trex Se Setup Guide
Ch. 2 is mounted from the inside of the right frame.
Figure C
●
Servo Centering and Direction can now be checked.
❍
Remove all servo arms from the servos.
❍
Set Aileron D/R Switch to 1.
❍
Turn on the transmitter.
❍
Make sure all of your trims are at 0.
❍
Set your collective (left stick) to center. It should be in the same position as the right stick.
❍
Disconnect your motor from the Electronic Speed Control (ESC) and plug a fully charged battery
pack into the ESC. Leave the helicopter stationary until the Gyro initiates.
❍
Begin putting the servo arms on each of the servos, lining the arm up as close to center as possible.
See Figure A, B and C above for arm orientation
. It is not necessary to hook up the linkage at this
time. Do not worry if they do not line up exactly. We will make adjustments later by using subtrim. If
you find a control horn is very far off from center try a different control horn.
❍
Now we can check servo direction.
■
Move your right stick (cyclic) to the right. Channel 2 servo arm should move down and
Channel 6 servo arm should move up.
■
If this is not the case you will need to reverse one or both of the servos depending
on what reaction occurred.
■
Move the right stick (cyclic) forward. The Channel 3 servo arm should move up while the
Channel 6 and 2 servo arms move down. The opposite applies when the right stick is pulled
back.
■
If this is not the case you will need reverse the Channel 3 servo.
■
Move the left stick (rudder) to the left. The Ch. 4 servo arm should move towards the tail of
the heli.
■
If this is not the case then you will need to reverse this servo.
■
Move the left stick (throttle) up and down. Ch 2, 3 and 6 should move together in direction
relation to the stick movement.
❍
If any servo reversing was necessary, you may have to check for servo arm alignment again to make
sure they are as close to center as possible.
❍
We will now adjust the subtrim to center any servo arms that need centering.
■
Turn the transmitter on if it is not already on.
■
Make sure both sticks are in the center position.
■
Push scroll and Increase at the same time to enter Function Mode.
■
Press scroll until you reach the SB-TRIM Menu.
http://www.digimemphoto.com/pdf/ (4 of 13)1/25/2006 7:09:05 PM
