Align Trex Se Setup Guide
Figure E
Figure G
●
Setting 0 pitch
❍
Check that transmitter sticks are at center.
❍
Set your pitch guage to 0 and place it on one of the main blades.
❍
Hold the flybar and blades level by lifting on the guage.
❍
If all is well your flybar and top of guage will be parallel showing your pitch is at 0.
❍
Do the same for the other blade.
❍
You should be right on if not, very close. You can make slight adjustments using the short linkage
connected to the blade grips.
Figure H
●
Now we can set your positive.
❍
Set your pitch guage to +10
❍
Place it on one of the main blades.
http://www.digimemphoto.com/pdf/ (6 of 13)1/25/2006 7:09:05 PM
