Align Trex Se Setup Guide
F
igure K
Figure L
#4 Setting up the tail rotor, tail rotor servo and gyro
●
Tail servo setup
❍
Turn the radio on if not already on.
❍
Set the Aileron D/R Switch to 0.
❍
The servo should be centered from the previous steps. If it is not you need to go back to the
centering section and do this servo again. (You need to be in flight mode 1.)
❍
With the servo centered, horn on, linkage connected, loosen the servo mount bracket so it can be
moved on the boom. Position the servo so the tail rotor blade pitch is 0 with the servo arm centered
as shown (figure M).
❍
Also the bracket needs to be rotated until the control arm runs parallel with the boom. (figure N)
❍
Tighten the bracket down once these items are aligned.
http://www.digimemphoto.com/pdf/ (8 of 13)1/25/2006 7:09:05 PM
