23
2) Adjustment Mode
The DJ-195 does not require a serviceperson to manipulate the components
on the printed-circuit board, except the trimmer when adjusting reference fre-
quency and deviation.Most of the adjustments for the transceiver are made by
using the keys on it while the unit is in the adjustment mode.Because the ad-
justment mode temporarily uses the channels, frequency must be set on each
channel before adjustments can be made.For instructions on how to program
the channels, see the “DJ-195 INSTRUCTION MANUAL” which came with the
product.In consideration of the radio environment, the frequency on each chan-
nel must be near the value (+/-1MHz) listed in the table below.To enter the
adjustment mode, set key lock and input 490217.Decimal point at 100MHz and
10MHz appears in LCD. (To release the mode, set key-lock and input 490217.)
Channel frequencies used in the adjustment mode
Channel
Channel function
Frequency
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Reference frequency adjustment
High power adjustment
Low power adjustment
Minimum frequency sensitivity adjustment
Medium frequency sensitivity adjustment
Maximum frequency sensitivity adjustment
S-meter ( 1 ) adjustment
S-meter ( FULL ) adjustment
Deviation
DTMF ( 1 ) test
DTMF ( D ) test
Tone 67 Hz test
Tone 88.5 Hz test
Tone 250.3 Hz test
DCS code 255 test
Tone burst test
Aging ( Not required to use )
145 MHz
145 MHz
145 MHz
130 MHz
145 MHz
174 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
145 MHz
Summary of Contents for DJ-195
