29
VHF minimum frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 6 by rotating the main tuning dial.
2. Set the minimum frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
VHF medium frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 7 by rotating the main tuning dial.
2. Set the medium
frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
VHF maximum frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 8 by rotating the main tuning dial.
2. Set the maximum
frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
UHF minimum frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 9 by rotating the main tuning dial.
2. Set the minimum frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
UHF medium frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 10 by rotating the main tuning dial.
2. Set the medium
frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
UHF maximum frequency sensitivity adjustment
See “Note on adjusting the sensitivity” later in this section.
1. In the adjustment mode, select channel 11 by rotating the main tuning dial.
2. Set the maximum
frequency sensitivity rotating the main tuning dial, while F
appears after the
key is pressed.
VHF S-meter (1) adjustment
1. In the adjustment mode, select channel 12 by rotating the main tuning dial.
The S-meter will show a single circle ( )
2. Enter “0” dB
µ
(EMF) with the transceiver tester (SSG).
3. Press the
key The transceiver beeps indicating the new setting has
been stored successfully.
Summary of Contents for DJ-596E
