Alkin W3 Series Instruction Manual & Parts List Download

Page: 12 / 83

W 3 S E R I E S
H I G H P R E S S U R E A I R C O M P R E S S O R

©ALKIN COMPRESSORS

Disconnect the power supply prior to attempting any repair or cleaning. Tag the power supply to avoid unexpected start
by someone else.

Keep electrical wiring, including terminals, in good condition. Replace any wiring that has cracked, cut, abraded or

otherwise degraded insulation or terminals that are worn, discolored and corroded. Keep all terminals clean and tight.

Keep grounded conductive objects such as tools, away from exposed live electrical parts such as terminals, to avoid arcing,
which might serve as a source of ignition.

Do not attempt to weld on the pressure vessels or any other parts or to the piping. Any such works or repairs can only be

made by certified technicians and with prior written approval of the manufacturer.

Keep a suitable BC or ABC fire extinguisher(s) nearby while servicing and operating the compressor. Keep oil, rags, trash,
leaves litter and other combustibles away from the compressor.

Do not spray volatile materials into the compressor intake, as serious damage to the compressor and personal injury or

death may result.

1.1.4 Moving parts

Keep Hands, arms and other parts of the body and clothing away from the belts, pulleys and other moving

parts. Do not attempt to operate the compressor with the belt guard removed.

Wear snug fitting clothing and confine long hair when working around the compressor, especially when exposed to hot
and /or moving parts. Make sure all persons are clear of the compressor prior to attempting to operate it.

Make adjustments only when the compressor is shut off. When necessary, make adjustments, than start the compressor to

check if the adjustment. If incorrect, shut the compressor, blow down the air, re-adjust, than re-start to check the
adjustment.

Keep hands, feet, floors, controls and walking surfaces clean and free from oil, water, anti freeze, or other liquids to

minimize the possibility of slips, falls and shock hazard.

1.1.5 Hot Surfaces, Sharp Edges and Sharp Corners

Avoid physical contact with hot oil, hot surfaces, sharp edges and corners. Keep all parts of the body away from
all points of air discharge and away from hot cylinder heads, discharge pipes and intercooler surfaces. Wear

personal protective equipment, including gloves and protective hat when working on or around the compressor.

Keep a first aid kit handy. Seek medical assistance promptly in case of injury. Don’t ignore small cuts and burns as they

may lead to infections.

1.1.6 Toxic and Irritating Substances

Do not use air from this compressor for breathing unless it is equipped with proper purification equipment and

in full compliance with OSHA standard 29 CFR 1910 and any other Federal, State and local codes and regulations.

Operate the compressor only in well ventilated areas. Lubricants used in this compressor are typical industrial oils designed
for use in high-pressure compressors. Accidental ingestion and skin contact should be avoided. Wash with soap and water

after skin contact. If swallowed, seek medical treatment promptly.