W 3 2 S E R I E S
H I G H P R E S S U R E B R E A T H I N G A I R C O M P R E S S O R
59
tightening, wich may result in over pressing and
crushing cartridge.
13.
Remove the tool and the adapter; the installation
of the cartridge is completed.
For filters, use similar procedures, except for the
cartridge which is not refillable and it needs to be
replaced periodically. See the instruction manual for
details.
2.5.10 Oil Filter replacement
1.
Screw off the bolts on oil filter head.
2.
Remove the oil filter head
3.
Remove the used oil filter element
4.
Install the new oil filter element.
5.
Check the o-rings on oil filter head.
Replace if necessary. Put back on the oil
filter head.
6.
Tighten the bolts & screws.
7.
Run the compressor. In the first 10
seconds, oil pressure should rise. Check
the oil pressure gauge. If, however, the
oil pressure do not rise in the first
minute, check the troubleshooting
section on oil pressure.
