To ensure your new pond pump is set up and running correctly, and to prevent
any accidental damage or injury, please read and follow the below instructions
carefully before using your product.
SAFETY
Important!
Disconnect the mains electricity supply before attempting any
installation / maintenance of any kind. Do not attempt to modify this unit in
any way and only use the recommended parts for replacement.
Ÿ
The pond pump should never be run dry as this will cause the unit to
overheat and cause permanent damage. The pump must be fully immersed
completely and never operated outside of water.
Ÿ
All connections must be earthed.
Ÿ
If the unit shows any signs of water leakage, or if the RCD switches off,
disconnect from the mains and remove the pump from the water.
Ÿ
The power cord of this appliance cannot be replaced; if the cord is damaged,
the appliance should be discarded. Never cut the cord.
Ÿ
Do not connect to any voltage other than that stated.
Ÿ
Do not install or store this unit where it will be exposed to temperatures
below freezing. During adverse weather conditions, remove and store the
pump in a sheltered place away from direct sunlight.
Ÿ
This pump is suitable for outdoor ponds only. Do not place in liquids other
than fresh water.
Ÿ
Do not use this pump for anything other than its intended use (i.e. do not use
in bathrooms, swimming pools etc).
Ÿ
Do not use with water above 90F or 30C.
Ÿ
Do not carry or pull the unit by its electrical cable.
Ÿ
Do not use this unit if it has a damaged cord, if it is malfunctioning or it is
dropped or damaged in any manner
Ÿ
Do not attempt to modify this unit in any way and only use attachments and
the recommended parts for replacement recommended by the
manufacturer.
Ÿ
Before installing, maintaining or handling your equipment, or before placing
your hands in your pond, ensure that the unit is disconnected from the
electricity supply.
