Owner’s Manual
25
Operation (cont’d)
Powering 120 Volt AC Tools And Equipment:
1
Prior to powering tools and equipment, make sure the generator’s rated
voltage, and amperage capacity (110/120VAC @ 2
7.5
AMPs) is adequate
to supply all electrical loads that the unit will power. If powering exceeds
the generator’s capacity, it may be necessary to group one or more of
the tools and/or equipment for connection to a separate generator.
2
Once the generator is running, simply connect the power cords of 110/
120 volt AC powered tools and equipment into the 110/120 volt AC dual
outlets. (See Figure G)
3
When finished using the generator, turn the engine power switch to its
“OFF” position. Turn the fuel valve to its “OFF” position.
4
Disconnect all electrical powered tools and equipment from the
generator’s 110/120 volt AC duel outlets. (See Figures E, F, and G.)
5
After the engine and generator have completely cooled, store generator
in a safe, clean, dry location (if not already installed).
CAUTION: ATTEMPTING TO POWER SENSITIVE
ELECTRONIC EQUIPMENT WITHOUT THE USE OF AN
APPROVED LINE CONDITIONER MAY CAUSE DAMAGE TO
THE EQUIPMENT.
ALL POWER AMERICA
IS NOT RESPON
-
SIBLE FOR
ANY DIRECT OR INDIRECT DAMAGE CAUSED
BY FAILURE
TO USE AN APPROVED LINE CONDITIONER.
Note: The Generator features an AC Non-Fuse Circuit Breaker
(5) to protect the AC circuit in case of an overload. Should an
overload occur, the Breaker will “trip” to its “OFF” position,
causing the Generator to automatically shut down. In this case,
refer to Step #1 above in this section. Then, reset the circuitry
system by turning the Circuit Breaker to its “ON” position. Restart
the Generator and continue powering the remaining tools and
equipment.
