HERA LS Series CD/DVD Duplication System / User Manual
15
Use this menu option to see data about the autoloader and its resources (firmware version, RAM
and CPU).
3. Device Info
Use this menu option to see data about the drives that are installed in the autoloader.
4. Load Default
Use this menu option to reset all of the options back to the manufacturer's default values. You
can use this function if your autoloader is acting abnormally.
5. Update Firmware
Use this utility to update the software in your autoloader. To update, insert the manufacturer’s
Certified Update CD into the 1
st
tray and make sure no other discs are in rest of the trays. Then
you can press the
Enter
button to update.
Important:
You should not upgrade your autoloader's firmware unless your system is becoming
unstable or you are advised to do so by Tech Support.
15. Loader Utilities (page 46)
Use the Loader Utilities menu options to access the various utilities built into the autoloader. You can
scroll between the various options using the
Up or
Down
button.
1. Drive Alignment
The Drive Alignment menu is used to check the mechanical alignment between the drives and
the robotic arm. See “Drive Alignment” on page 46 for more information.
2. Alignment Protection
Enabling Alignment Protection makes each drive tray quickly slide in and out after a disc has
been loaded into it. This ensures that the disc sits properly in the disc indentation of the tray by
“shaking” the disc into place. See “Alignment Protection” on page 47.
16. Manage Accounts (page 47)
Use this menu option to:
Create user accounts and passwords to prevent unauthorized use of the autoloader.
Edit existing user account information, including name and password.
Delete existing user account(s).
Enable/Disable this feature.
For additional information, refer to “Introduction to Manage Accounts” on page 16.
17. AUTOCOPY (Hidden – page 40 and 50)
The AUTOCOPY function simplifies the copy process by allowing you to stack blank media on a
spindle(s), place the master on top of the stack on the first spindle, and press the
Enter
button on
AUTOCOPY
key in the main menu. It will load the content of the top disc of the 1
st
input spindle (master
disc) into the Reserved Partition of the Hard Drive and copy it to blank disc(s) below it and other input
spindle(s) if exists.
To activate this function, you need to activate it by going to “13. Setup” -> “9.AUTOCOPY” and turn it on.