HERA LS Series CD/DVD Duplication System / User Manual
21
Loader Processing
Drive 1 <- Input Bin
Processing...
Please Wait
Loader Processing
Drive 2 <- Input Bin
Input Bin Empty(20)
Continue?
PASS 100 FAIL 0
Job Completed! Press OK to Finish
This information screen shows what is happening. In this case, the loader has
taken a disc from the input spindle and is placing it into Drive 1.
The loader will continue to remove discs from the input spindle and place those into drives until either all of the
drives are full, or the count that you loaded into the counter is reached.
It takes a few seconds for the autoloader to recognize all the discs.
After two or three seconds of processing time, one of the following
Copy Progress
screens will appear.
Copying... H4012MB
0/21 12%
Copying... H4012MB
0 12%
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity of the
master disc.
“12%” indicates the current progress
of the duplication.
“0/21” indicates you have a project
size of 21 copies and you have made 0
copies so far.
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity of
the master disc.
“12%” indicates the current progress
of the duplication.
“0” indicates you have made 0 copies
so far.
Note:
It is normal to see the progress indicator stay at 0%-10% and 100% for approximately 30 seconds
for CD duplication and up to one minute for DVD duplication. That is caused by the initializing and
finalizing stages.
Once the duplication run is completed, the loader will remove the finished
disc from the drive and place the successful copy on the Output Spindle
and if there are any bad/NG copy to the reject area.
The loader will then pick up another blank disc and load it into the drive. This is then repeated for each disc.
The copying process will continue until you either run out of blank discs or until
the count that you loaded into the counter is reached.
If you run out of blank discs and the job is not complete, the autoloader will give you an opportunity to fill the
spindle:
Important:
When you add discs to the input spindle, be sure to remove your finished discs from the
Output Spindle.
At this point you can either put more discs on to the input spindle and press
the
Enter
button to continue, or press the
ESC
button to terminate your
project.
Once the autoloader is through, you will see the following screen:
“PASS 100" indicates that you made 100 successful copies.
Loader Processing
Drive 1 -> Output Bin