HERA LS Series CD/DVD Duplication System / User Manual
22
Duplicator B.30
1. Copy (MM)
Duplicator B.30
8. Master Mode (SM)
Master Mode:
Single Master
Master Mode:
Multi Master
Duplicator B.30
1. Copy (MM)
“FAIL 0" indicates that you have no failures for this job.
At the bottom of the screen, you will see the scrolling message: “Job Complete! Press OK to Finish”
Press the
Enter
button once again and you shall see the “Access Log” menu. You can press the
Enter
button one more time to see the log that indicates the number of passes and fails for every drive/tray, or simply
press the
ESC
button to go back to the main menu. It is highly recommended to check the log when your job
has an abnormal amount of failures.
1.2. Making Copies in Multi Master Mode
This mode does not require you to manually load your master. Simply place the master disc(s) on top of the stack
of blank discs needed for that particular job of the master disc. This mode is ideal if you have numerous master
discs and fewer copies for each master disc.
The Multi Master mode uses the Reserve partition to temporarily store the content of the current master disc.
Once the task is complete and a new master disc has been detected, the reserve partition's content (of the
previous master disc) will be replaced with the content of the new master disc.
For more information on Multi Master Mode, see “Single Master and Multi Master Modes” on page 16.
Turn on your autoloader and wait until it has booted up. It should take several minutes for the autoloader to go
through its self adaptive test and auto-calibration procedures. You should see the following signifying your
autoloader is ready:
Make sure the Master Mode is set to Multi Master mode (MM). If it is not,
use the
Up or
Down
button to navigate to the
8. Master Mode
screen.
If it is already in Multi Master mode (MM), please skip to the step that starts
the copy process.
Press the
Enter
button to enter the
Master Mode
Menu and you will see
a screen similar to one of the following:
Use the
Up or
Down
button to select Multi Master Mode. Press the
Enter
button to submit your selection.
Use the
Up or
Down
button to navigate back to the
1. Copy
Menu.
Place your master discs and blank discs onto the Input Spindle as described in “Single Master and Multi Master
Modes” on page 18. In general, the order of the discs on the spindle will be,
from top to bottom
:
The master disc for the first job
The blank discs for the first job
The master disc for the second job
The blank discs for the second job
The master disc for the third job