*030690-000-70*
030690-000-70
© Allegion 2014
Printed in U.S.A.
030690-000-70 Rev. 10/14-d
Customer Service
1-877-671-7011
www.allegion.com/us
Installation Instructions
F-Series
Keyed Locks
ROSE
INSIDE
LEVER
UL
LATCH
SHIELD *
OUTSIDE
LEVER
ASSY
#8 COMBO
SCREWS
#10-32
MACHINE
SCREWS
INSIDE
SPINDLE
ASSY
LATCH ASSY
NOTCHES
* NOTE: UL LATCH SHIELD IS ONLY
REQUIRED WITH UL LATCHES
1.
MARK DOOR
2.
DOOR PREPARATION
3.
INSTALL STRIKE
4.
INSTALL LATCH SHIELD
6.
INSTALL OUTER TRIM
7.
INSTALL INNER SPINDLE
ASSEMBLY
A.
Mark height line on edge of door
approximately 38” from floor.
B.
Using the proper backset, mark 2
¹⁄₈
” hole on
both sides of the door.
C.
On the outside of door, mark notches.
D.
Mark the center of the door edge for the latch.
A.
Bore 2
¹⁄₈
”
hole thru from
both sides of
door to prevent
splintering door
finish.
B.
File notches on
outside of door being careful not
to exceed the 2
¹⁵⁄₃₂
" dimension.
C.
Bore 1” hole for latch on door
edge.
D.
Using the latch faceplate as a
guide, trace outline and mortise
door edge so latch is flush with
door.
NOTE:
Hollow metal doors must be properly
reinforced for lock support. If support was not
furnished contact door manufacturer.
1”
HOLE
2
¹⁄₈
”
HOLE
A.
Use strike locating tool or pointed
object to locate position for hole in frame.
B.
Bore 1” x
³⁄₄
” deep hole. Use strike as a
template and mortise to the proper depth.
C.
If dust box is to
be used, clear area
with wood chisel.
FOR UL LATCH OPTION ONLY
A.
Insert latch shield
(closed end first)
from the outside of the door.
CAUTION:
Failure to
use the latch
shield with a
UL latch will
invalidate the
UL listing of
this product.
5.
INSTALL LATCH
A.
Insert latch into door, making certain that
bevel faces direction of closing door.
B.
Secure with two #8 combo screws provided.
A.
Align spindle with latch unit
and insert outer trim into door.
A.
Align spindle assembly with square
shaft and slide into place.
NOTE:
Locking button must be positioned
towards the edge of the door.
B.
Secure with two screws provided.
locking button
