*47280190*
47280190
2
Install spindle with spring, side 1.
a
b
c
3
Install spring cage, side 1.
a
b
c
d
Arrow matches
down rotation of lever
Insert mounting post
thru #3 position of
spring cage as shown
3
3
4
Install spindle/spring/spring cage, side 2.
(reverse angle)
a
Insert spindle
and spring.
Arrow
matches
down
rotation
of lever.
Insert mounting post
thru #3 position of
spring cage as before.
Long post feeds into short post on
opposite side and vice versa as shown
below.
Door
edge
long
short
long
short
3
3
c
b
5
Hand thread screws into mounting posts on opposite side,
then fully tighten.
Flush with
channel
Flush with
channel
(reverse
angle)
PT9000 Series, Rose
Installation Instructions
PT-Series Mortise Trim
Door Handing
IMPORTANT! Check lock handing before installation.
If necessary to change handing:
1. Pull out the latch and rotate 180°.
2. Handing screw must be installed on the interior side of the chassis. If necessary, move
the screw to the opposite side.
Handing screw
(install on interior side)
Pull and
rotate 180°
1
Install lock chassis and lightly tighten screws.
L
Do not fully tighten chassis mounting screws at this time.
Ø
⁷⁄₈
" (22)
for Thumbturn
Non-Standard
prep
4
⁷⁄₁₆
" x 6
¹⁄₆
" x 1"
(113 x 154 x 25mm)
Parts
H
J
G
F
C
I
K
B
E
A
D
Required
Supplied
Phillips
screwdriver
3mm
hex key
2.5mm
hex key (thumbturn only)
installation
aid
Tools
L
N
M
Q
P
Optional
thumbturn
O
R
Parts
A Spindles (2)
B Springs (2)
C Left hand spring cage
D Right hand spring cage
E Mounting posts (2)
F Mounting screws (2)
G Surface mount screws (4)
H Left hand lever/rose
I Right hand lever/rose
J Set screws (2)
K 3mm hex key
Optional Thumbturn Parts
L Spindle
M Surface mount screws (4)
N Rose
O Nylon bushing
P Thumbturn
Q Set screw
R 2.5mm hex key
