DX012 Getting Started Guide
AP11841 Issue 1
Rear panel
Vents
Ensure good ventilation at the sides and back of the unit. Avoid
obstruction of vents while operating. Avoid dirt or liquid ingress.
Mains power input
Switch, IEC connector and fuse for the built-in
universal voltage PSU. This accepts voltages from 100 to 240V AC 50/60Hz.
Secure the cable to the plastic P-clip using a T20 screwdriver.
Rack ears
The rack ears can be reversed so the unit is mounted with the XLR connectors
facing the rear of the rack. Using a Torx T8 driver, remove the 3x M3 screws
holding the rack ears in place on each side, reposition the rack ears as shown
below, and secure them again using the same screws.
Only use the M3x5mm countersunk screws provided with the unit.
Alternative
position (rear
mounting)
Default
position
