CLACK
4
3
2
1
3
140G-ELTT
(Ordered separately)
LED
- Green
- Verde
- Grün
- Vert
- Verde
- Red
- Rosso
- Rot
- Rouge
- Rojo
- Device ON
- Dispositivo acceso
- Einrichtung eingeschaltet
- Dispositif allumé
- Dispositivo encendido
- Change battery
- Sostituire batterie
- Batterie ersetzen
- Remplacer batteries
- Sustituir baterías
DIR 1000721R0507
Version 04
(B0399) - B1581
Copyright © 2017 Rockwell Automation, Inc. All Rights Reserved. Printed in Italy.
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Publication
140G-IN101E-MU-P - August 2017
Rockwell Automation maintains current product environmental compliance information on its website at
http://www.rockwellautomation.com/rockwellautomation/about-us/
sustainability-ethics/product-environmental-compliance.page
PROCEDURA DI CONTROLLO
- CONTROLLO LED:
tutti i led del relè si
devono accendere
- ULTIMA INDICAZIONE DI TRIP:
Il LED si accende solo quando
avviene un trip
- LED:
resta acceso finchè 140G-ELTT
Tester è connessa al relè
- PRONTO PER TRIP
- Fasi 2 e 3 per test Trip Unit
DIAGNOSTIC PROCEDURE
- UNIT CHECK LED:
all the LEDs in the relay
must come on
- LAST TRIP INDICATION:
LED will come on only
when a trip occured
- LED: remains on for
as long as the 140G-ELTT
Tester is connected to
the relay
- READY TO TRIP
- Steps 2 & 3 to test Trip Unit
DIAGISTIKABLAUF
- EINEITHSPRUF-LED:
Alle LEDs des Relais müssen
aufleuchten
- ANGABE DER LETZTEN AUSLOSUNG:
LED leuchtet nur, wenn es eine
trip.
- LED: Bleibt angeschaltet,
bis die Einheit 140G-ELTT Tester
an die Relais angeschlossen ist.
- AUSLOSEBEREIT
- Stufe 2 und 3 um zu Trip Unit testen
PROCEDIMIENTO DIAGNOSTICO
- LED CONTROL UNIDAD: todos los
led del relé se deben
encender
- INDICACION ULTIMA ACTUACION:
LED se enciende sólo cuando hay
un trip
- LED: queda encendido
mientras la 140G-ELTT Tester
permanezca conectada con el relé
- LISTO PARA LA ACTUACION
- Fase 2 y 3 para Trip Unit test
-
PROCÉDURE DE DIAGNOSTIC
- UNIT CHECK LED : toutes les
diodes du relais doivent
s'allumer
- LAST TRIP INDICATION :
la DIODE allume seulement
quand il ya un trip
- LED: la DIODE reste
allumée tant que 140G-ELTT
Tester est connectée au relais
- READY TO TRIP
- Phase 2 et 3 pour test Trip Unit
