Operation
Chapter 4
426
2.
Set baud switch to 9600 baud. Set the track switch to the track
containing diagnostics program.
3.
Set the power ON/OFF switch to the ON position.
4.
Insert the data cartridge into the recorder.
5.
Wait for the recorder to complete the repacking operation.
NOTE: If the recorder is turned off while a tape rewind is in progress,
the data on the tape will be altered.
6.
Halt the processor.
7.
Set the DATA SELECT switch to the CASSETTE position. If your
system is not equipped with this switch, set the S-register to 34000
(octal).
8.
Press STORE.
9.
Press PRESET.
10. Press BBL.
11. Wait for the tape motion to stop. Both the READ FROM TAPE and
DATA OUT indicators should be off. After a successful program
load, the 8200 processor switch panel will display 102077 (octal).
12. Press RUN and the diagnostics will display the first question.
Series 8200 programs stored on a cassette may be erased so that the
cassette may be re-used. use the following procedure to erase cassette
programs:
1.
Install the recorder as described in chapter 3.
2.
Set the BAUD RATE switch to 9600 baud.
3.
Set the TRACK SELECT switch to the area of the tape to be erased.
Select either TRACK 1, TRACK 2, OR CONT (to erase the entire
tape).
4.
Set the power ON/OFF switch to the ON position.
5.
Wait for the recorder to complete the repacking operation.
6.
Position the recorder’s cartridge head at the point from which the
recorder is to erase the tape. Advance or rewind the tape as
necessary.
7.
Select the KYBD (keyboard) mode.
8.
Enter the following command through the keyboard: CA,IZ].
Erasing Series 8200 Programs
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
