98
Rockwell Automation Publication 2715-UM001A-EN-P - July 2015
Chapter 7
Troubleshooting
Clean the Display
A protective overlay can help extend the life of the terminal and make it easier to
clean the display.
provides catalog numbers for overlays.
To clean the display, follow these steps.
1.
Disconnect power from the terminal at the power source.
2.
To clean the display and prevent scratches, use a clean sponge or soft cloth
with mild soap or detergent.
3.
Dry the display with a chamois or moist cellulose sponge to avoid water
spots.
Remove Paint and Grease
To remove paint or grease from the bezel that is properly mounted in a NEMA,
UL Type, or IP rated enclosure, follow these steps.
1.
Rub lightly with isopropyl alcohol (70% concentration).
2.
To remove residue, use a mild soap or detergent solution.
3.
Rinse with clean water.
Equipment Wash Downs
ATTENTION:
Do not use abrasive cleaners or solvents, they can damage the
display. Do not scrub or use brushes.
Do not apply cleaning solution directly on the terminal screen, the solution can
drip or seep onto the gasket. Apply cleaning solution to a clean sponge or soft
cloth, and gently wipe the screen to remove the dirt and grime.
ATTENTION:
Cleaning a display while power is applied can result in
unintended activation of screen items.
ATTENTION:
Do not use a high-pressure washer for cleaning the front bezel of
the terminal. A high-pressure washer can damage the terminal.
Do not use a high-pressure washer for cleaning vented enclosures. Water can enter
the enclosure and damage the terminal and other equipment.
Summary of Contents for 2715-15CA
