Rockwell Automation Publication 825-UM004D-EN-P - November 2012
239
Appendix
D
ASCII Port Relay Command Summary
ASCII Port Relay
The ASCII Port Relay Command Summary table below lists the front serial port
ASCII commands associated with particular activities. The commands are shown
in upper-case letters, but they can also be entered with lower-case letters.
Serial Port Command
Access Level
Command Description
2AC
1, 2
Go to Access Level 2.
ACC
0, 2
Go to Access Level 1.
ANA
2
Test analog output (refer to Chapter 12: ASCII Serial Communications
for details).
DAT
1, 2
View date.
DAT
mm/dd/yyyy
1, 2
Enter date in MDY format if DATE_F setting is MDY.
DAT
dd/mm/yyyy
1, 2
Enter date in DMY format if DATE-F setting is DMY.
DAT
yyyy/mm/dd
1, 2
Enter date in YMD format if DATE-F setting is YMD.
MET
1, 2
Display instantaneous metering data.
MET
k
1, 2
Display instantaneous metering data
k
times, where
k
is 1…32767.
MET T
1, 2
Display thermal and RTD metering data.
MOT
1, 2
Display motor operating statistics report.
MOT R or C
2
Reset motor operating statistics.
PAS
2
Show existing Access Level 1 and Level 2 passwords.
PAS 1
xxxxxxxx
2
Change Access Level 1 password to
xxxxxxxx
PAS 2
xxxxxxxx
2
Change Access Level 2 password to
xxxxxxxx
QUI
1, 2
Go to Access Level 0.
SER
1, 2
Display all Sequential Events Recorder (SER) data.
SER
n
1, 2
Display the
n
most recent SER records starting with record
n
.
SER
n1 n2
1, 2
Display SER records
n2
…
n1
, starting with
n2.
SER
d1
1, 2
Display all SER records made on date
d1.
SER
d1 d2
1, 2
Display all SER records made from dates
d2
…
d1
, inclusive, starting with
d2
.
SER R or C
1, 2
Reset SER data.
SET
2
Enter/change relay settings.
SET P
2
Enter/change Serial Port F settings.
SET M
2
Enter/change I/O mapping settings.
SET
name
2
For all
SET
commands, jump ahead to a specific setting by entering setting name, e.g.,
50P1P
.
SET …TERSE
2
For all
SET
commands,
TERSE
disables the automatic
SHO
command after settings entry.
SHO
1, 2
Show relay settings.
SHO A
1, 2
Show all relay settings: enabled and disabled/hidden.
Summary of Contents for 825-P
