24
Rockwell Automation Publication 857-UM002C-EN-P - February 2018
Chapter 4
Configure the Base 857 Relay
External Analog Inputs for 857-RAD
The 857-RAD is equipped with four individual isolated analog inputs. If used,
these inputs must be configured within the base relay for proper operations.
Analog Input Settings
Select External Analog Inputs.
In the External Analog Inputs tab, you do not need to adjust the first 12
channels that are associated with the RTD Inputs- if you followed the
RTD
Inputs Quick Setup for 857-RAD on page 23
.
IMPORTANT
Some of the parameters are preset by the hardware configuration. Not all
fields need to be changed.
Parameter Value
Notes
AI Enabled
On, Off
Enable the analog input channel by clicking on the appropriate location under the AI Enabled area. Turn ON or OFF each individual
channel. These will be the last four lines of the table.
AI Slave Address
1…247
The AI Slave Address must match the hardware selection made on the dip switch on the side of the 857-RAD module.
AI Modbus Address 1…9999
Select the units of measure for each channel by clicking on the appropriate location under the AI Unit area. Select mA.
The other units listed in the drop list are not presently available.
AI Register Type
HoldingR, InputR
Modbus RTU register type. Relay sets these according to the selected device type.
AI Signed
On, Off
AI Signed should be left as OFF. For other uses please contact Rockwell Automation.
AI Offset
-32000…32000
AI Offset is subtracted from Modbus value, before running X/Y scaling. This is normally left at 0.
x1, y1, x2, y2
-32768…32768
X1 and X2 are the minimum and maximum Modbus values. Y1 and Y2 are the minimum and maximum scaled values (see
Figure 11
).
Summary of Contents for 857-RAA
