6
ArmorBlock MaXum 8 Input / 8 Output Module
Publication 1792D-5.20 - October 1998
I/O connectors for this module are shown below.
Output Power and DeviceNet Cables
Output power and DeviceNet cables are described in the installation
publications for the cable base assembly of your choice. Refer to the
following publications:
• 1792D-5.9 ArmorBlock MaXum
Cable Base Installation Guide
• DN-6.7.2 DeviceNet Cable Planning and Installation Manual
Communicate With Your ArmorBlock MaXum I/O Module
This ArmorBlock module’s I/O is exchanged with the master through a
poll, change of state, or cyclic connection.
The module consumes and produces I/O data as follows:
Cyclic - allows configuration of the block as an I/O client. The block will
produce and consume its I/O cyclically at the rate configured.
Type of I/O Connections
Consumes
Produces
Cyclic
1 Byte
4 Bytes
Polled
1 Byte
4 Bytes
Change of State
1 Byte
4 Bytes
I-4
I-5
I-6
I-7
O-4
O-5
I-2
I-3
O-2
O-3
O-6
O-7
Network Status
Module Status
I-0
I-1
O-0
O-1
Auxiliary Power
41517
Input 0
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Output 0
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Output 7
Connector A
Connector B
Connector C
Connector D
Connector E
Connector F
Connector G
Connector H
