Installing A ControlNet Cable System
3-15
Publication 1786-6.2.1 - April 1998
Attaching The Connectors To The Cable
1.
Slip the crimp ferrule onto the cable. Push it back to the sheath area
of the cable to keep it out of the way for the moment.
2.
Place the center pin over the center conductor.
Important:
Make sure that the center pin slips onto the center
conductor completely. The back shoulder of the
center pin should be up against the white insulation.
If it is not, recheck the length of the center conductor.
3.
With the center pin in place, use the crimp tool to crimp the pin
into place.
4.
Slide the ControlNet connector onto the cable.
crimp ferrule
stripped cable
20077a
20077a
center pin
center conductor
The smaller hexagonal crimping
notch is for crimping the center pin
onto the center connector.
20167
77002c
braid and tape shield
connector base
connector
