Allen Concepts Tightwatt 2, User Manual

I Cautions & Warnings

IMPORTANT: READ IMMEDIATELY!

In order for your timer to function normally, it must be released from the in-store demo mode. With the 9V battery back-up installed or 

connected to power, simultaneously press and hold both buttons for 5 seconds. Do not perform this procedure unless the front cover is 

in place and there is no risk of electrical shock.

DANGER – ELECTRICAL SHOCK HAZARD

Failure to follow instructions may result in personal injury and/or death.

Read and understand instructions before installation. Retain these instructions.

The jack underneath the battery cover is for TightWatt brand accessories only.

Plugging anything else into this jack will void the warranty and may damage the device.

ATTENTION: READ CAREFULLY BEFORE ATTEMPTING TO INSTALL YOUR TIGHTWATT

®

2 ENERGY-SAVING TIMER. FAILURE TO COMPLY 

COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!  RETAIN FOR FUTURE REFERENCE.

Thank you for purchasing a TightWatt

®

2

 energy-saving timer. This timer has been specifically designed to keep

your pool looking beautiful year-round, while using a minimum amount of electricity. Our patent-pending technology automatically 

varies your filter run-time with the seasons – to save you money! By using less energy, you’re also helping the environment.

General Safety Information:

WARNING: Disconnect all power before installing or servicing this timer or its connected loads.

1. Follow all local electrical and safety codes, National Electrical Code (NEC), as well as Occupational Safety and Health Act (OSHA).

2. If the power disconnect point is out of sight, lock it in the “OFF” position and tag it to prevent unexpected application of power.

3. The timer case must be grounded if a metal case is used.

4. Do not exceed the maximum current carrying capacity of this time switch.

5. Always replace the top cover and Plexiglass® insulator before turning power “ON”.

2