1A
OPERATIONS
1.14 Periodic Maintenance Schedule
The chart below list basic trowel and engine maintenance. Refer to engine manufacturer's Operation Manual
for additional information on engine maintenance. A copy of the engine Operator's Manual was supplied with
the machine when it was shipped. To service the engine pull the seat locking pin out and tilt seat back.
DAILY EVERY 20 EVERY 50
EVERY 100 EVERY 300
HOURS HOURS HOURS HOURS
GREASE TROWEL ARMS
X
CHECK OIL LEVEL IN G-BOX
X
CHECK FUEL LEVEL
X
INSPECT AIR FILTERS
X
REPLACE AS NEEDED
CHECK AND TIGHTEN
X
EXTERNAL HARDWARE
GREASE CONTROL LINKAGE
X
CHECK DRIVE BELTS
X
CHECK VALVE CLEARANCE
X
CHANGE ENGINE OIL
X
REPLACE OIL FILTERS
X
OIL CROSSHEADS
X
GREASE TROWEL G-BOX
X
REPLACE SPARK PLUG
X
CHANGE HYDRAULIC FLUID
ANNUALY
1.15 Trowel Gearbox
1. Check Oil levels in the gearbox daily (every 8 hours) Add oil if oil level is below the check sight glass. To add
oil tilt trowel back and remove the side plug. Add Oil through hole opening. Replace plug after proper level has
been achieved. DO NOT Fill past the plug. Use only Mobil Oil SHC 634, synthetic ISO VG 460.
2. Each Gearbox has a grease fitting on top cover that must be greased (2 SHOTS ONLY) every 300 operat-
ing hours. Use only Mobilith SHC 220. Extended pressure grease.
1A-13
Summary of Contents for RAZORBACK RIDERS PRO1200C
