LIMITED W
LIMITED W
ARRANTY
ARRANTY
and LIMIT
and LIMIT
A
A
TION OF LIABILITY
TION OF LIABILITY
Allen Engineering Corporation ("Allen") warrants its products to be free of defects in material or workmanship
for the following periods:
A. New Machines and Parts
One Year
The above listed warranty periods are effective for Allen Machines with a first day of use by End User on April
1, 2007 or later. Warranty period begins on first day of use by End User. This first day of use is established by
the date of a completed Allen Warranty Card or a Bill of Sale to the End User. All warranty is based on the fol-
lowing limited warranty terms and conditions, including the disclaimer of implied warranties and consequential
damages.
1.
Allen's obligation and liability under this warranty is limited to repairing or replacing parts if, after
Allen's inspection, there is determined to be a defect in material or workmanship. Allen reserves the choice to
repair or replace.
2.
If Allen chooses to replace the part, it will be at no cost to the customer and will be made available
to the Allen Distributor, Dealer, or Rental Center from whom the End User purchased the product.
3.
Replacement or repair parts, installed in the product, are warranted only for the remainder of war-
ranty period of the product as though they were the original parts.
4.
Allen does not warranty engines. Engine warranty claims should be made directly to an authorized
factory service center for the particular engine manufacturer.
5.
Allen's warranty does not cover the normal maintenance of products or its components (such as
engine tune-ups and oil & filter changes). The warranty also does not cover normal wear and tear items (such
as belts and consumables).
6.
Allen's warranty will be void if it is determined that the defect resulted from operator abuse, failure to
perform normal maintenance on the product, modification to product, alterations or repairs made to the product
without the written approval of Allen. Allen specifically excludes from warranty any damage to any trowels
resulting from an impact to the rotors.
7.
Impact damage is not covered under the Allen Gear Box warranty.
8.
Allen will pay shop labor on warranty items at the Allen Shop Labor Rate in existence on the date of
the warranty claim. An Allen Labor Chart will determine the time allowed to complete a repair and will govern
the shop labor hours that will be allowed.
9.
Allen will pay freight on warranty replacement parts at worldwide standard ground rates. No warran-
ty replacement parts will be shipped air freight at the expense of Allen. Allen only pays outbound freight charges
when sending warranty replacement parts to the customer via ground service. Allen does not pay any inbound
freight. However, if Allen determines this to be a warranted item, only then will Allen reimburse the customer for
inbound freight at standard ground rates.
10.
ALLEN ENGINEERING CORPORATION'S WARRANTY POLICY WILL NOT COVER THE FOL-
LOWING: TAXES; SHOP SUPPLIES; ENVIRONMENTAL SURCHARGES; AIR FREIGHT; TRAVEL TIME;
LOSS OF TIME; INCONVENIENCE; LOSS OF RENTAL REVENUE; RENTAL COSTS OF EQUIPMENT USED
TO REPLACE THE PRODUCT BEING REPAIRED; LOSS OF USE OF THE PRODUCT; COMMERCIAL LOSS;
OR ANY OTHER CHARGES WHATSOEVER OR ANY LIABILITIES FOR DIRECT, INCIDENTAL, OR CONSE-
QUENTIAL DAMAGE OR DELAY.
11. ALLEN ENGINEERING CORPORATION MAKES NO OTHER WARRANTY, EXPRESSED OR
IMPLIED. THIS LIMITED WARRANTY IS IN LIEU OF THE WARRANTY OF MERCHANTABILITY AND FIT-
NESS. THERE ARE NO OTHER WARRANTIES THAT EXTEND BEYOND THE DESCRIPTION ON THIS
DOCUMENT.
12.
No Allen employee or representative is authorized to change this warranty in any way or grant any
other warranty unless such change is made in writing and signed by an officer of Allen Engineering Corporation.
© Allen Engineering Corporation
Revised 4/1/07
