22
Weekly Maintenance
Check fastener torques
•
Ensure that the engine is switched off and the cutting
cylinder is stationary.
•
Check and where necessary tighten the bearing
retaining fasteners.
•
Check and where necessary tighten the belt and
chain tensioner fasteners.
•
Check and where necessary tighten the engine and
drive belt mounting fasteners.
Cleaning the fuel sediment bowl
WARNING - PREVENT ACCIDENTS
Wear protective gloves and safety glasses
•
Locate the fuel sediment bowl. Move the fuel
cut-off switch to the
OFF
position.
•
Place a container underneath the sediment bowl
to catch any fuel and then unscrew the retaining
screw at the bottom.
•
Remove the screw and sediment bowl, together with the rubber gasket, and
retain in a safe place.
•
Wash the sediment bowl using fresh petrol.
•
Replace the sediment bowl by reversing the procedure outlined above, ensure
that the rubber gasket is put back in place.
•
Move the fuel shut-off tap to the
ON
position
.
Summary of Contents for BUFFALO 24"
