12
Maintenance and storage
Always wear thick gloves when manually rotating a cutting cylinder.
Check that all nuts, bolts and screws are sufficiently tight so as to ensure that the equipment is in
safe working condition.
To reduce the risk of fire, keep the engine and exhaust area free of grass, leaves and other debris.
Wipe off excess grease.
Frequently check fuel lines and fittings for cracks or leaks and replace if necessary.
Replace worn or damaged parts.
Ensure that all safety decals are properly secured and in good condition.
Never work on the equipment while the engine is running.
Take care to prevent entrapment of the fingers between moving blades and fixed parts during
maintenance activities.
Allow the engine and exhaust to cool before storing in any enclosure.
If the fuel tank has to be drained this should be done outdoors.
Always chock the roller when the mower is being left in storage
Health and Safety at Work Act
In accordance with section 6 of the Health and Safety at Work Act 1974 the C34 has been designed and
constructed so that, in so far as is reasonably practical, it will not endanger the safety and health of those
working with it. This is, however, subject to the equipment being properly used and maintained according
to the conditions stated in this manual and elsewhere, which have been found necessary as a result of the
research and testing of Turfmech Machinery Limited and Allett.
Summary of Contents for C 34
