F016J11384-A
26
Voyants
Charge
4 voyants verts
La batterie est complètement chargée
3 voyants verts
La batterie est chargée à 70 %
2 voyants verts
La batterie est chargée à 40 %
1 voyant vert
La batterie est chargée à 10 %
Les voyants s’éteignent
La batterie n’est pas suffisamment chargée;
elle doit être immédiatement rechargée
Serre-câbles
(C) Utilisez les serre-câbles fournis pour immobiliser les câbles sur la poignée.
Bac de ramassage
(D) (modèles Liberty 30 et 35) Pincez les extrémités du support du bac de ramassage et
insérez les goupilles dans le trou pivot de la tondeuse. En plaçant le support sur sa position
la plus basse, accrochez l'avant du bac de ramassage dans le support pour l'immobiliser.
(E) (Liberty 43) Insérez la goupille fixe du support du bac de ramassage dans le trou pivot
de la tondeuse. Rétractez le piston du support puis relâchez-le de manière à ce que la
goupille s'enfonce dans le trou pivot opposé. En plaçant le support sur sa position la plus
basse, posez le bac de ramassage sur le support pour l'immobiliser.
Batteries et chargement
Vérifiez la charge de la batterie
Voir l'illustration (F).
Appuyez sur le bouton d'indication de charge de la batterie. Les voyants s'allument en
fonction du niveau de charge. Voir le tableau ci-dessous :
Chargement de la batterie
Voir les illustrations (G) et (I).
REMARQUE : À la livraison, la batterie n'est pas complètement chargée. Il est recommandé
de la charger complètement pour obtenir la durée de fonctionnement maximum. Cette
batterie lithium-ion n'a pas de mémorisation et elle peut être chargée n'importe quand. Dans
des conditions normales, une batterie 4 Ah se recharge complètement en 105-120 minutes.
Pour charger la batterie, procédez comme suit :
1.
Branchez le chargeur dans une prise secteur.
2.
Installez la batterie dans le chargeur jusqu'à ce que vous entendiez le CLIC.
3.
Une fois la batterie complètement chargée, la LED verte s'allume. Débranchez le
chargeur, appuyez sur le bouton de déblocage de la batterie puis retirez-la du chargeur.
Le chargeur utilisé est un chargeur diagnostic. Ses voyants à LED s'allument dans un ordre
précis qui indique l'état actuel de la batterie. Les indications sont les suivantes :
fr