ALL
FASTENERS.COM
|
13
()
14. PREPARING & INSERTING THE FUEL CELL
Read section titled “5. SAFETY INSTRUCTIONS - FUEL CELL” before moving forward.
PREPARING THE FUEL CELL
DANGER
The fuel cell is flammable
Keep away from ignition sources.
DO NOT spray toward an open flame or heat source.
DO NOT smoke when handling fuel cell.
Keep stem of fuel cell away from face and skin. Expanding gases cause low temperatures. DO NOT come in contact
with these gases.
DO NOT inhale.
Keep out of reach of children.
CAUTION
If the gas leaks form the metering valve or the gas cartridge (after attaching the metering valve), replace with a new
metering valve.
DO NOT attempt to reuse the metering valve. Replace with new metering valve.
To attach the metering valve to the fuel cell:
1. Separate the metering valve and the cap from the gas cartridge. (14.1).
2. Stem downward, putting the metering valve incline forward to the
bowl cover. (14.2)
3. Press downward on the rear of the metering valve until it seals with no
gas leakage. (14.3)
4. Check the metering valve: Press the metering valve stem on the fuel cell two or
three times against a stationary object and release. If gas is not dispersed, fuel cell
is empty and replace it.
5. Observe safety regulations.
The fuel cell is not ready to insert into the nailer.
INSTALLING THE FUEL CELL
Cap
Stem
Fuel Cell
Metering Valve
14.1
14.2
14.3
