allgood Modric 2460, Fixing Instructions

DO NOT install this product in areas where the 

following may be present or occur: 

•   Corrosive or flammable gases, liquids or vapours. 

•   Ambient temperatures higher than 40ºC or less  

  than -5ºC. 

•   Possible obstructions which would hinder the  

    access or removal of the hand dryer.

IMPORTANT 

Read these instructions before 
commencing with the installation

. 

P.04

Allgood plc, 

63-83 Brearley Street, Birmingham, B19 3NT 

www.allgood.co.uk

Allgood plc, 

63-83 Brearley Street, Birmingham, B19 3NT 

www.allgood.co.uk

P.01

Safety and guidance notes
A.

  All wiring to be in accordance with  

    the current I.E.E. Regulations, or the  

    appropriate standards of your 

    country and MUST be installed by a  

    suitably qualified person.

B. 

The Hand Dryer should be provided  

    with a local isolator switch capable  

    of disconnecting all poles, having a  

    contact separation of at least 3mm.

C.

  Ensure that mains supply (Voltage,  

    Frequency, and Phase) complies  

    with the rating label.

D.

  The Hand Dryer should only be used  

    in conjunction with fixed wiring.

E. 

The Hand Dryer should not be  

    used where it is liable to be subject  

    to direct water spray for prolonged  

    periods of time.

F.

   This appliance can be used by  

    children aged 8 and above and 

    persons with reduced physical,  

    sensory or mental capabilities or  

    lack of experience and knowledge  

    if they have been given supervision  

    or instruction concerning use of the 

    appliance in a safe way and   

    understand the hazards involved. 

    Children should be supervised to  

    ensure that they do not play with  

    the appliance.Cleaning and user  

    maintenance shall not be made by  

    children without supervision.

H.

  Stationary appliances not fitted with  

    means for disconnection from the  

    supply mains having a contact  

    separation in all poles that provide  

    full disconnection under over  

    voltage category III, the instructions  

    state that means for disconnection  

    must be incorporated in the fixed  

    wiring in accordance with the  

  wiring rules.

3

Servicing instructions

The minimum service period for the 
dryer should be every 3 months or 
more frequent intervals as experience 
dictates: 

1.

  Isolate the Hand Dryer from the  

    electricity supply before servicing.

2. 

Remove dust, fluff and any other  

    build up of foreign matter from  
    inlet and outlet grille areas    
  (Illustration 3). 

ORIGINAL FIXING INSTRUCTIONS 

Modric 2460 surface mounted hand dryer

ORIGINAL FIXING INSTRUCTIONS 

Modric 2460 surface mounted hand dryer

IMPORTANT

After installation or servicing, units must be checked, 
and only left when electrically and mechanically safe.