P.02
P.03
ORIGINAL FIXING INSTRUCTIONS
Modric 2460 surface mounted hand dryer
ORIGINAL FIXING INSTRUCTIONS
Modric 2460 surface mounted hand dryer
Mounting instructions
The Hand Dryer must be fixed to a solid
supporting wall. The recommended
distance from finished floor level to
the bottom of the unit should be as
follows:-
• Male washrooms
1168mm
• Female washrooms
1118mm
• Disabled washrooms
1016mm
• Children aged 14-17
1118mm
• Children aged 11-13
1016mm
• Children aged 8-10
914mm
• Children aged 4-7
672mm
To ensure ease of installation and
subsequent maintenance, the horizontal
distance to any adjacent wall should be
less than 0.2 metres.
To install follow the steps below:
1.
Drill 7mmø x 50mm deep four
places using template supplied
to mark up position (For fitting to
masonary).
2.
Insert nylon plugs.
Wiring instructions
Always ensure that the installation
conforms to the current edition of
the I.E.E. wiring regulations, BS 7671
(UK) or the appropriate standards in
your country. Ensure that the unit is
separately fused with a suitably rated
fuse and that it is connected to the
supply with a double pole isolating
switch having a contact separation of
at least 3mm. Care should be taken
that single insulated conductors cannot
come into contact with the mounting
surface.
3.
Screw in screws leaving
approximately 5mm gap.
(Illustration 1).
4.
Locate dryer assembly back plate
over screw heads through key hole
apertures. pull down against surface
and fully tighten screws
(Illustration 2).
5.
Locate cover on back plate and
locate and tighten screws from
underneath.
1
2
Allgood plc,
63-83 Brearley Street, Birmingham, B19 3NT
www.allgood.co.uk
Allgood plc,
63-83 Brearley Street, Birmingham, B19 3NT
www.allgood.co.uk
WARNING
The hand dryer MUST be isolated from the power
supply during installation or maintenance.
IMPORTANT
After installation or servicing, units must be checked,
and only left when electrically and mechanically safe.
Summary of Contents for Modric 2460
Page 3: ......
