Installation
800532
10
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Washer Slide Extension
(Coin Slide Models Only)
Remove slide extension, shoulder screw, plastic boot,
actuator, actuator support, screws and lockwashers
from the accessories bag. Install slide extension as
follows:
1. Unlock and open service door. Remove locking
rod holding coin slide to front of security cabinet.
NOTE: Refer to
Figure 2
for steps 2 through 4.
Figure 2
2. Assemble plastic boot (No. 36165) onto actuator
support (No. 685592).
3. Assemble actuator (No. 36164) to actuator
support (No. 685592) using shoulder screw
(No. 36166).
4. Place actuator and support assembly onto slide
extension, and install screw and lockwasher
(No. 03950).
5. Install assembed slide extension through coin
slide opening of security cabinet by reaching
through service door opening.
6. Assemble slide extension (No. 685593) to top
side of coin slide using two screws and
lockwashers (No. 03950), and tighten firmly.
Refer to
Figure 3
.
Figure 3
7. Reinstall assembled coin slide in security
cabinet. Close and lock service door.
After slide extension has been installed, check washer
operation as follows:
1. Connect electrical power to washer.
NOTE: To determine if slide functions properly,
allow washer to complete its cycle, and for timer to
stop, before starting evaluation process.
2. Place required number of coins in slide. Push
slide in slowly and listen for coins to drop into
coin drawer.
3. Push slide in a little farther and observe through
service door opening that actuator drops beyond
timer clutch. Continue pushing slide all the way
in and pull back. Confirm that the actuator will
rotate timer clutch and wash cycle starts.
NOTE: Washer will not start until PUSH-TO-
START has been pressed.
H067I
To reduce the risk of electric shock, fire,
explosion, serious injury or death:
• Disconnect electric power to the washer
before servicing.
• Never start the washer with any guards/
panels removed.
• Whenever ground wires are removed
during servicing, these ground wires
must be reconnected to ensure that the
washer is properly grounded.
W003
WARNING
H067I
H068I
H068I
Summary of Contents for 800532R3
