33711
1
© Copyright 2002, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Table of Contents
Section 1 – Safety Information
Locating an Authorized Servicer ............................4
Customer Service ....................................................5
Nameplate Location ................................................5
Model Identification ................................................6
1. No Hot Water ...................................................7
2. No Cold Water .................................................8
3. No Warm Water ...............................................8
4. Water Fill Does Not Stop At Proper Level ......9
5. Timer Does Not Advance (Mechanical
Timer Models only) .........................................9
6. No Agitation ...................................................10
7. Constant Agitation .........................................10
8. Slow Spin Or No Spin ....................................11
9. Constant Spin .................................................11
10. Drive Motor Overload Protector Cycles
Repeatedly ......................................................12
11. Outer Tub Does Not Empty ...........................12
12. Excessive Vibration .......................................12
13. Water Leaking From Outer Tub ....................13
14. Wall Receptacle Polarity Check ....................15
15. Power Cord to Cabinet Top, Cabinet Top to
Control Hood Mounting Bracket, Pressure
Switch Mounting Bracket and Ground Tab
on Graphic Panel ............................................16
16. Main Wire Harness to Top Left Rear Corner
Gusset of Cabinet ...........................................17
17. Motor to Mounting Bracket ...........................17
Section 5 – Service Procedures
18. Control Hood Assembly ................................19
19. Electronic Control ..........................................19
20. Timer ..............................................................21
21. Temperature Switch .......................................22
22. Pressure Switch ..............................................22
23. Graphics Panel ...............................................22
24. Loading Door .................................................22
25. Agitator ..........................................................24
26. Agitator, Drive Bell And Seal Assembly .......24
27. Front Panel .....................................................26
28. Pump Belt ......................................................27
29. Drive Belt .......................................................27
30. Motor And Mounting Bracket .......................29
31. Idler Lever And Pulley ..................................29
32. Motor Drive Pulley Or Pump Pulley .............31
33. Motor Switch .................................................31
34. Pump Assembly .............................................31
35. Cabinet Top Assembly ...................................32
36. Door Switch ...................................................33
37. Out-of-balance Switch ...................................34
38. Mixing Valve Assembly ................................36
39. Washtub And Clothes Guard .........................36
40. Hub And Seal Kit Assembly ..........................40
41. Outer Tub .......................................................45
42. Drive Pulley And Helix .................................48
43. Brake Assembly .............................................50
44. Lower Bearing Housing .................................51
45. Transmission Assembly .................................53
46. Balance Ring ..................................................59
47. Upper Bearing Assembly ...............................59
48. Snubber Pads ..................................................60
49. Leveling Legs ................................................63
50. Pressure Switch ..............................................64
51. Belt (Agitate And Spin) .................................64
52. Belt (Pump) ....................................................64
53. Out-of-balance Switch ...................................65
54. To check continuity through motor harness
and motor .......................................................67
55. To check continuity through base harness,
56. G.E. Motor Check (Start Windings) ..............68
57. G.E. Motor Check (High and Low
Windings) .......................................................69
