33711
87
Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
72. SYMPTOM: WASHER WILL NOT AGITATE PROPERLY
Washer will not
agitate properly?
Broken, loose or incorrect
wiring?
YES
By-pass pressure switch to allow agitation
without water in washtub.
With power cord unplugged, remove and insulate
wire from terminal “P6” on control.
YES
NO
Correct wiring.
With loading door closed, plug in power cord.
Choose cycle and press GO pad.
Loading Door Switch
120 Volts between terminal “N.O.” on
motor relay K3 and “P1” (neutral)?
Motor Relay K3
120 Volts between “COM” terminal on
motor relay K3 and “P1” (neutral)?
NO
Inspect loading door
switch.
YES
YES
NO
Replace control.
Motor Relay K1
120 Volts between “P2” (START/AGITATE)
and “P1” (neutral) on control?
YES
NO
Replace control.
Motor Relay K2
Zero Volts between terminal “P3” (START/SPIN)
and “P1” (neutral) on control?
YES
NO
Replace control.
Problem not related to electronic control.
