22
33711
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
IMPORTANT: To avoid timer damage, do not allow
timer to be struck on corners, edges of frame, or on
timer shaft.
21. TEMPERATURE SWITCH
Refer to Figure 6 for switch removal.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
22. PRESSURE SWITCH
Refer to Figure 5 or 6 for switch removal.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
IMPORTANT: When installing pressure switch,
blow air through pressure hose before connecting
hose to switch to remove any condensation that may
have accumulated in the hose.
23. GRAPHIC PANEL
Refer to Figure 5 or 6.
a. Remove six screws (3 on top and 3 at lower
front) holding hood assembly to control hood
rear panel and cabinet top.
b. Disconnect wires from component parts and
carefully remove components from control
hood assembly.
NOTE: Refer to appropriate wiring diagram when
rewiring component parts.
c. Bend tabs on graphic panel (located inside of
control hood) straight out toward rear of hood.
d. Carefully remove graphic panel off front of
control hood.
24. LOADING DOOR
a. Open loading door. Refer to Figure 9.
b. Remove two screws holding left hinge to door
and remove hinge and gasket. Refer to
Figure 9.
c. With loading door raised to the vertical
position, swing left side of door toward front of
washer. Refer to Figure 10, procedure one.
d. Rotate door so door is upside down. Refer to
Figure 10, procedure two.
e. Carefully remove loading door, right hinge and
bushing from cabinet top. Refer to Figure 10,
procedure three.
NOTE: Reverse procedure when installing door.
Figure 8
Control Hood
Mounting
Plate
Timer
Attaching
Screws
Cross
Shaped
Holes
Figure 9
Hinge
Attaching
Screws
Hinge
Attaching
Screws
Loading
Door
Hinge
(Left)
Hinge
(Right)
