32
33711
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
35. CABINET TOP ASSEMBLY
a. Remove two screws from bottom edge of front
panel. Refer to Figure 15.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 22.
c. Remove two cabinet top hold-down screws.
Refer to Figure 22.
d. If area or space permits, tape loading door
closed and lift cabinet top to a vertical position
by hinging it on the rear hold-down bracket.
NOTE: Cabinet top is self-supporting, however, a
small chain may be used for additional support.
Refer to Figure 23.
IMPORTANT: Before lowering cabinet top into
position, pivot outer tub forward far enough to
prevent damaging (bending) the out-of-balance
switch lever.
Figure 22
Cabinet Top
Hold-Down
Screw
Cabinet Top
Hold-Down
Screw
Wire
Harness
Clip
Wire Harness
Disconnect
Blocks
Figure 23
Chain
