33711
73
Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
60. WASHER OPERATION
Close the loading door. The washer will not
agitate or spin with the loading door open.
NOTE: If the loading door is opened while the
washer is filling with water, the water flow will stop
for about three seconds, then the water fill will
continue.
Select the LOAD SIZE WATER LEVEL. If
agitation has started and a higher water level is
desired, move the control to RESET, then make
your water level selection.
NOTE: When the control is released, it should not
remain at the RESET position.
IMPORTANT: Holding the LOAD SIZE WATER
LEVEL control lever in the RESET position can
cause flooding of the washer.
Press one of the cycle selection pads to select a
cycle which is appropriate for the type of fabric
being washed: REGULAR, PERM PRESS,
DELICATES, KNITS or SOAK. These are
automatic, preprogrammed cycles.
Select desired cycle options by pressing the
various pads to the right of the STATUS LIGHTS.
Refer to “Customizing Preprogrammed Cycles”
for detailed information.
Press the GO pad. Washer will start immediately
and stop automatically when the cycle has
completed. Washer will not start until the GO pad
is pressed.
The washer will stop (pause) for a brief period
of time before the wash and rinse spins.
Figure 60
Model No.
Level
Electronic Control
Part No.
AA9431 and NA8831
I
31304P
AA8431
II
31305
AWE951
I
33925P
AWE931
I
31307
AWE852
II
33927P
