33711
75
Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
62. STATUS LIGHTS
The STATUS lights illuminate to show you at a
glance what is happing inside the washer.
63. OTHER FEATURES
WASH
Lights up during the wash portion
of the cycle.
RINSE
Lights up during the rinse portion of
the cycle
SPIN
Lights up during the final spin.
FILTER
Flashes whenever the lint filtering
system is activated.
SOAK
Lights up whenever the load is
soaking. Also, lights up during the
soak portion of the SOAK cycle.
WASH and
SOAK
Both light up during the wash
portion of the DELICATES and
KNITS cycles and during periods of
soaking.
Digital
Display
Shows you the length of the wash
cycle you have selected and counts
down the number of minutes
(excluding water fills) remaining in
the cycle. The display also shows
the number of hours remaining
during the DELAYED START
countdown on those models
equipped with DELAY START.
Flashing
Digital
Display
Light
Tells you the GO pad must be
pressed in order to continue the
cycle. Close the washer loading
door. The washer will not run with
the loading door open.
Flashing
Digital
Display
Light and
Signal
Load is out-of-balance. Open the
loading door, redistribute load and
close loading door. Press the GO
pad. Washer will continue with the
cycle.
GO
Press the GO pad to start washer.
Washer will not run until the GO
pad is pressed.
STOP
Press the STOP pad to stop washer
at any point in the cycle. Washer
will stop and remain at that portion
of the cycle until the GO pad is
pressed. At that time, the cycle will
continue where it left off.
Pressing the STOP pad two times in
succession will cancel the cycle.
RESET
The RESET pad functions the same
as the STOP pad. Pressing it once
stops the washer, pressing it two
times in succession cancels the
cycle.
