84
33711
Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
69. SYMPTOM: INDICATOR LED’S WILL NOT LIGHT WHEN SELECT PAD IS PRESSED
*
For precision, this measurement must be taken with a digital multi-meter set on 200 Ohm scale.
Approximately 120 Volts
between “P4” and “P1” (neutral)
and 120 Volts between “P5” and
“P1” (neutral)?
NO
YES
Unplug power cord. Disconnect
“P1”, “P4” and “P5” terminals on
control.
Approximately 120 Volts at
power outlet?
YES
NO
Refer to
for blown
fuse or tripped breaker.
Power cord plugged in?
YES
NO
Plug in power cord.
Display window or indicator
LED’s will not light when the
SELECT pad is pressed?
YES
Broken, loose or incorrect
wiring from power cord to
control?
NO
YES
Correct wiring.
Recheck troubleshooting
sequence. If problem persists,
replace control.
NO
*86 Ohms ± 30% between
terminals “P4” and “P1”
(neutral) on control?
Replace control.
Broken, loose or incorrect
wiring?
YES
YES
Correct wiring
Recheck troubleshooting
sequence. If problem persists,
replace control.
NO
