86
33711
Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
71. SYMPTOM: WASHER WILL NOT FILL OR WRONG TEMPERATURE FILL
Select Extra-Large load size.
*Make sure washtub is empty when choosing cycle
to ensure that pressure switch has reset. Use
ADVANCE TIMER pad to advance cycle to SPIN if
necessary.
**NOTE: Both hot water relay “K4” and cold
water relay “K5” are energized for warm water fill.
Only hot water relay “K4” will be energized for hot
water fill and only cold water relay “K5” will be
energized for cold water fill.
Washer will not fill or wrong
temperature fill?
Broken, loose or incorrect
wiring?
YES
Correct wiring.
NO
YES
Plug washer in and
close loading door.
*Choose cycle and
press GO pad.
Pressure Switch
120 Volts between terminals “P6”
and “P1” (neutral) on control?
Inspect pressure
switch.
NO
YES
Hot Water Relay K4
**120 Volts between “P7” and “P1”
(neutral) on control?
Replace
control.
NO
YES
Cold Water Relay K5
**120 Volts between “P8” and “P1”
(neutral) on control?
Replace
control.
NO
YES
Problem not related to
electronic control.
