8
33711
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
2. NO COLD WATER
3. NO WARM WATER
POSSIBLE CAUSE
TO CORRECT
Cold water supply faucet is closed.
• Open faucet.
Kinked cold water inlet hose.
• Straighten or replace hose.
Clogged mixing valve screen, or screen in outer end
of inlet hose nearest water supply faucet.
• Disconnect cold water inlet hose, and clean or replace
screen.
Inoperative cold water mixing valve solenoid.
• Test solenoid and replace if inoperative.
*Inoperative timer.
• Test timer and replace if inoperative.
*Inoperative temperature switch.
• Test switch and replace if inoperative.
Inoperative pressure switch.
• Test switch and replace if inoperative.
Clogged pressure hose.
• Remove and clean or replace hose.
Broken, loose or incorrect wiring.
• Refer to appropriate wiring diagram.
†Inoperative electronic control
• Refer to Section 8 to check out the electronic control
operation.
* Mechanical Timer Models Only
† Electronic Control Models only
POSSIBLE CAUSE
TO CORRECT
No hot water.
• Refer to Paragraph 1.
No cold water.
• Refer to Paragraph 2.
