F232073
21
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 3
Programming
The computer board is inside the control module.
Near the center of the board is a small toggle
switch: this is the RUN/PROGRAM mode switch.
The RUN/PROGRAM switch is normally in the up
(RUN mode) position. To enter PROGRAM mode,
flip the switch to the down position. The display
will now show the current temperature in the sump.
Since the keypad operates in a slightly different
fashion when in PROGRAM mode, pay careful
attention to the programming instructions provided
in this manual.
Key Functions In Programming Mode
Up
– The
Up
key is used to increase cycle numbers
(1 through 30) and other numerical values such as
times or temperatures (when creating wash
formulas).
Down
– The
Down
key is used to decrease cycle
numbers (1 through 30) and other numerical values
such as times or temperatures (when creating wash
formulas).
Start
– The
Start
key acts as an enter key in
program mode. Use this key to enter data and move
to the next function in the cycle.
Stop
– The
Stop
key saves all data and terminates
the programming procedure. If it is the first key
pressed in PROGRAM mode, the computer enters
SETUP mode. The
Stop
key can be pressed again to
exit SETUP mode and return to PROGRAM mode.
Setup Mode
SETUP mode allows the selection of degrees
Fahrenheit or degrees Celsius for the temperature
display.
To enter SETUP mode, press the
Stop
key while the
display is showing the temperature in the sump.
Once in SETUP mode, use the
Up
or
Down
key to
change the selected option. Use the
Start
key to
accept the selected option, either “FAr” or “CEL.”
Press the
Stop
key to exit SETUP mode.
Dangerous voltages are present in the
electrical control box(es) and at the motor
terminals. Only qualified personnel familiar with
electrical test procedures, test equipment, and
safety precautions should attempt adjustments
and troubleshooting. Disconnect power from
the machine before removing the control box
cover, and before attempting any service
procedures.
:$51,1*
SW005
Summary of Contents for Cabinet Hardmount SC27SN
