Operation
13
F232172
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Table 2 (Continued)
Display
Meaning
CAnt / OPEn
Control cannot unlock the door
COIn
Control will interpret both coin inputs as signals from a drop coin meter meaning coins must
fall through slot at a certain rate to be counted as valid coins.
Con1/dEnO
Denomination assigned for coin 1 input (example: .25 would mean a US quarter)
Con2/dEnO
Denomination assigned for coin 2 input (example: 100 would mean a US dollar)
CArd
Control will interpret the coin 2 input as a START signal from a card reader with no timing
max restriction, meaning the signal can last any amount of time once recognized.
USH1
“Wash 1” segment
USH2
“Wash 2” segment
USH3
“Wash 3” segment
USH4
“Wash 4” segment
rIn1
“Rinse 1” segment
rIn2
“Rinse 2” segment
rIn3
“Rinse 3” segment
rIn4
“Rinse 4” segment (final rinse)
donE
Cycle has concluded
drAI
Drain selected for segment; also indicates in drain step during 2 speed version test cycle and
in Rapid Advance. Refer to
Programming Manual.
----
Flashes for a period of time (for safety) after power up while keeping outputs OFF
nodr
No drain selected for segment. Machine does not drain for segment.
SUP6/S 12
Supply 1 and 2 together
EFIL
Machine set up for extra fill valve. Valve MUST be installed on machine. “EFIL” displays
when programmed for extra fill step.
nEFL
Machine not equipped with extra fill valve
HEAt
Machine heat functions enabled in control. Machine MUST be equipped with electric or
steam heat capabilities.
noHt
Machine heat functions NOT enabled in control. “noHt” MUST be selected in set up mode if
machine does not have electric or steam heat capabilities.
bEEP
Beep enabled during supply 2 (bleach) and at end of cycle
nobP
Beep disabled during supply 2 (bleach) and at end of cycle
S-xx
Setup/configuration code = xx (xx means setup code)
P-yy
Factory cycle ID program code = yy (yy means setup code)
Adv
Rapid Advance, refer to Programming Manual.
Erdn
Drain count error (depending on model)
Erfl
Fill error count (depending on model)
E Pr
The number of times power has been interrupted during a cycle
CyC
Cycle counter
