800170
15
Section 3 Troubleshooting
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
b. Electronic Coin Drops:
If coin drop is not accepting coins, perform the
following:
1. Clean coin drop. Refer to
2. On electronic coin drops with an old-style
and
),
test and replace tension spring using the
following instructions.
Remove Coin Drop From Machine
1. Disconnect electrical power to machine and drop.
2. Remove coin drop from machine.
Test Tension Spring
1. Push coin return button to open and close coin
drop cover to clear possible coin jams. Refer to
.
2. Manually hold down coin drop cover and insert
coin. Refer to
.
3. If coin drop now operates properly, replace
tension spring using instructions on following
pages.
Replace Tension Spring
1. Move tension spring downward until cover catch
2. Open cover for coin drop.
3. Place a small flathead screwdriver under right
side of tension spring and lift up. Refer to
.
4. Use screwdriver to move spring approximately 3
mm to left.
5. Lift spring over left tab. Refer to
Figure 2
Figure 3
MIX7B
Coin Drop
Cover
Coin Return
Button
Tension Spring
MIX6B
Coin Drop
Cover
Figure 4
Figure 5
DRY2088N
Cover Catch
Tension Spring
MIX2B
Small Flathead
Screwdriver
Right Side of
Tension Spring
Left Tab
