156
800170
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
87. COIN DROP
a. Removal:
(1) Unlock control panel. Refer to
Step 1
.
(2) Pull top of control panel away from control
cabinet far enough to allow lifting control
panel up and off the rail support of the
control cabinet front. Refer to
Step 2
.
(3) Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 21, Step 3
.
NOTE: Carefully place protective padding around
control panel assembly to keep panel assembly from
damaging washer front panel during coin drop
removal. Allow panel assembly to hang down
supported by wire harness.
(4) Reach into control cabinet to feel position
of coin drop.
(5) Disconnect coin drop harness at disconnect
block.
(6) Use a 3/8 inch square drive socket, with
number 310P4–quarter inch Ratchet
Extension Tool, to remove 2 locknuts
holding coin drop to front of control
.
NOTE: A 3/8 inch square drive socket, size 7/16
inch, fits over end of the 310P4 Extension Tool. A
1/4 inch ratchet fits in the other end. Refer to
.
(7) Lift back end of coin drop and pull drop
straight back until front edge of the drop’s
front face plate clears the 2 guide wires.
(8) Carefully slide drop straight back until
drop clears inside wall of control cabinet.
Carefully remove drop out through control
panel opening.
b. Installation:
(1) Lift coin drop up on coin drawer housing.
(2) Line up holes in the front face plate of coin
drop with the 2 guide wires. Slide coin
drop forward, making sure guide wires are
through holes in front face plate of coin
drop.
(3) Slide coin drop forward all the way until
front face plate of coin drop is up against
the control cabinet front, with the coin
return stop completely through slot.
(4) Using a 3/8 inch square drive 7/16 inch
socket with number 310P4 1/4 inch
Ratchet extension Tool, reinstall both
locknuts and tighten locknuts firmly.
(5) Reconnect coin drop wire harness.
(6) Reinstall control panel in control cabinet
and lock control panel.
