800170
185
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
104. BEARING HOUSING
.
b. Remove control panel. Refer to
.
c. While supporting lower front access panel,
remove two screws from bottom edge of panel.
.
d. Gently lower front access panel to disengage
panel locators from bottom edge of front panel.
IMPORTANT: When installing pulley, always use a
new cap screw to prevent screw from loosening
during operation.
NOTE: When installing new cap screw, apply a
thread locking compound to screw threads and
torque new cap screw to 240 minimum to 260
maximum inch pounds (27.5 to 29.7 Nm).
e. Remove dispenser drawer using special tool,
No. 318P4. Refer to
f. Working through the control panel opening,
remove two screws holding bottom flange of
control cabinet front to top flange of front
panel, then remove bottom two corner screws.
.
g. Open loading door. Carefully remove wire
clamp ring from groove with small flat blade
screwdriver. Spring is located in the 6 o’clock
position. Refer to
.
h. Grasp the door seal. Refer to
.
i. Using a circular motion, pull seal up, out and
.
j. When seal releases from lip of front panel, pull
out and remove the seal.
k. Remove front panel (with loading door
attached) away from washer as far as wires
permit. Refer to
.
l. Unplug door lock harness connectors and the
wire harness clips along top flange of front
. Disconnect wires
from door switch and remove front panel with
loading door attached.
NOTE: Refer to wiring diagram when rewiring
door switch.
m. Loosen clamp and remove door seal hose
connection at dispenser. Refer to
IMPORTANT: When installing door seal hose, pull
hose tie tight to prevent damage. Refer to
n. Loosen large clamp and remove door seal off
.
NOTE: Door seal installation can be improved
using water or soap solution to work seal around
circumference of loading door opening. Be sure to
orientate seal with the tab in the 12 o’clock position.
o. Disconnect ground wire from outer tub front
panel. Refer to
.
p. Remove nut, washers and screw holding clamp
ring to outer tub front panel. Refer to
q. Remove rubber seal from outer tub front panel
and discard.
IMPORTANT: Always replace seal with a new seal.
Spray or apply a mixture of diluted laundry
detergent to assist in installation of new seal. The
“puffy” side of seal should be installed to the inside
for best results.
NOTE: Install clamp screw with threads and nut
facing downward. Refer to
. Install metal
clamp ring by placing clamp ring opening at
approximately the 10 o’clock position to ensure no
interference is encountered with side panel or the
underside of the control cabinet. Tighten screw and
nut until a spacing of one inch is achieved at the
clamp ring opening. Tap clamp ring all around
while tightening the screw and nut.
r. Run belt off pulley while slowly turning pulley.
s. Remove belt from motor shaft.
t. Remove cap screw (left hand thread),
lockwasher and flat washer holding pulley to
inner basket shaft. Refer to
.
u. Remove pulley from shaft.
v. Carefully remove inner basket out through
front of washer.
