800170
215
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
Section 6
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
132. CABINET LEVELING LEGS
a. Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on
any type of carpeting is not recommended.
b. Loosen locknuts and adjust the leveling legs
until the washer does not rock. Refer to
.
c. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
d. Remove rubber feet from accessories bag and
place on all four leveling legs. Refer to
.
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION
Figure 79
Com
me
rcia
l W
ash
er / D
rye
r
W
AS
HE
R
DR
YE
R
H173SE1B
Base
Level
Locknut
Leveling
Leg
(3/8 inch)
Rubber
Foot
Spacer
Base
Locknut
Rubber
Foot
Leveling
Leg
(1/2 inch)
MODELS WITH THE LETTER
“E” IN THE EIGHTH
CHARACTER OF THE
MODEL NUMBER
MODELS WITH THE LETTER
“H” OR “J” IN THE EIGHTH
CHARACTER OF THE
MODEL NUMBER
